UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Can't Put Feeder Motor Back Together for Ultimaker 2
Posted
(edited)
· Can't Put Feeder Motor Back Together for Ultimaker 2
DO NOT TAKE THE 6 PANELS APART. Dont' take even one panel off. You can fix anything without taking these apart.
Instead remove the rear left metal cover. It is held on by 2 screws (or one screw on older models) and only takes a minute to remove. Then you have access to the feeder motor and can position it with one hand while screwing the screws in with the other hand.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,224
DO NOT TAKE THE 6 PANELS APART. Dont' take even one panel off. You can fix anything without taking these apart.
Instead remove the rear left metal cover. It is held on by 2 screws (or one screw on older models) and only takes a minute to remove. Then you have access to the feeder motor and can position it with one hand while screwing the screws in with the other hand.
Edited by GuestLink to post
Share on other sites
Westporter 0
Thank You so Much! I Haven't touched it yet. I'll be sure to fix that when I get back to school Monday
Have a nice weekend!
Link to post
Share on other sites