Selection of a material

[RAJATSWIN1324 0]

hello everyone,

I am doing my project, in which i have to fabricate a part using ultimaker 3D printer. After fabricating, i am gonna do some thermal and compressive testing on my part. There are variety of materials available in the website. If any one of you have past experience with the material in ultimaker, then could you please suggest me best material for fabrication. I know that ABS and PLA will be on the top of  list but i was wondering if someone could tell me about materials listed below:-

1. Woodfill

2.CPE

3.NYLON

4.CONDUCTIVE

5.MAGNETIC

   Thanks

Edited March 4, 2016 by Guest

[SandervG 1,521]

I would recommend you read this blog first, it is especially about materials and should be very helpful to you!