UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
my blowing fan for the electronics sounds like a Jet Engine!
Posted
· my blowing fan for the electronics sounds like a Jet Engine!
Is the noise like air, or is there a mechanical noise too? In the last case it would help to peel the sticker off, put a drop of sewing oil(you should have it for your silver rods anyway, if not, buy it!) on it. That should to the trick
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
(Sorry, was out of office when this released)
This update is for...
All UltiMaker S series
New features
Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
Recommended Posts
peggyb 169
does it stay that way if you leave it on?
most of the time it settles after a few minutes, or tapping the bottom plate might help..
It is a familiar thing... some worse than others.
Link to post
Share on other sites
quinten-algra 0
hey tnx for the reply
tapping does not help iam printing now so i can see if it wil stop making the sound
Q
Link to post
Share on other sites