Jump to content

sudden temperature drop at start (fan off...)


Erik_Es

Recommended Posts

Posted · sudden temperature drop at start (fan off...)

An UM1 which has been working fine for over 2 years recently developed a problem: after preheating until temperature is stable, the temp measurement suddenly drops by about 6 degrees the moment the printer starts moving towards the home position. The fan is off, so that's not it.

It causes terrible temp swings in the bottom layer, as you would expect. After a while the temp balances out again, but I'm not sure whether the temperature is actually right then...

Any ideas ?

  • Link to post
    Share on other sites

    Posted · sudden temperature drop at start (fan off...)

    to be honest I don't know... but when it happens at the first movement my first thought is to check cables and connectors from the sensor and heater. Another thought is that the sudden extra power consumption may have something to do with it? just thinking out lout...

  • Link to post
    Share on other sites

    Posted · sudden temperature drop at start (fan off...)

    Cables & connectors are OK, don't see any problems during printing, even when fiddling with the wires quite shamelessly.

    Power supply might be the problem, I'll check that.

    Thanks

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...