UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Maintenance: Fan Speed - Does it activate all 3 fans in test? UM2(+)
Posted
· Maintenance: Fan Speed - Does it activate all 3 fans in test? UM2(+)
The third fan only comes on if the board gets above 40C. You could heat the temp sensor to 50C and it should come on. This is only true of the newer printers that were made more recently - I'm going to very inaccurately guess - jan 2015 and newer. Circuit boards from before then turn the 3rd fan on at power up.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,243
The third fan only comes on if the board gets above 40C. You could heat the temp sensor to 50C and it should come on. This is only true of the newer printers that were made more recently - I'm going to very inaccurately guess - jan 2015 and newer. Circuit boards from before then turn the 3rd fan on at power up.
Link to post
Share on other sites