UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Big problem with temperature control with ABS printing
Posted
· Big problem with temperature control with ABS printing
Does the setpoint change or just the temperature? if the setpoint changes then its software, if the setpoint stays the same then there must be a problem with the heater/cabling/thermocouple
Paul
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Another Cura release has arrived and in this 5.8 beta release, the focus is on improving Z seams, as well as completing support for the full Method series of printers by introducing a profile for the UltiMaker Method.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
phanc60844 0
Does the setpoint change or just the temperature? if the setpoint changes then its software, if the setpoint stays the same then there must be a problem with the heater/cabling/thermocouple
Paul
Link to post
Share on other sites