print speed??

[coyote 0]

Hello

What is exactly print speed??

If i set a print speed of 100mm/s i should see the print head moving at 100mm/s but i seenothing that high. I think it's more 10mm/s.

What wrong?

A part of that print quality is pretty good

[joergen 2]

Hello

What is exactly print speed??

If i set a print speed of 100mm/s i should see the print head moving at 100mm/s but i seenothing that high. I think it's more 10mm/s.

What wrong?

As a wild guess, you have set a min layer time that forces cura to print as slow as you mentioned it.

[coyote 0]

thanks a lot. that's exactly that.

The print layer time is set to 10sec and as the piece is really small. print speed goes to the minimum...