Jump to content
Ultimaker Community of 3D Printing Experts
MarkHoe

Help to setup slicing engine with more cooling than default?

Recommended Posts

Hey everybody,

I have been upgrading my UMO+ with dual cooling. (almost like the UMO2).

Now i can see that by tuning the cooling om my printer while printing helps the printquality.

Therefore i would like a little bit of help with my settings so i can by default increase the cooling by about 30-40units.

I would like to make it a default setting so that i dont have to make a lot of changes to the gcode everytime i slice.

I use Repetier Host and slice with Cura engine. (if that helps)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Taking Advantage of DfAM
      This is a statement that’s often made about AM/3DP. I'll focus on the way DfAM can take advantage of some of the unique capabilities that AM and 3DP have to offer. I personally think that the use of AM/3DP for light-weighting is one of it’s most exciting possibilities and one that could play a key part in the sustainability of design and manufacturing in the future.
        • Like
      • 3 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!