Jump to content

Ultimaker Original leaning prints on heated bed

LePaul

By LePaul
in UltiMaker 3D printers

 Share

Recommended Posts

LePaul

LePaul 324

Posted
Posted · Ultimaker Original leaning prints on heated bed

A couple months ago I installed the heated bed and right off, noticed the heated bed Z-cover squeaks as it is making contact with the back of the printer. I'm not 100% sure it is to blame for this, but I wanted to put that out there

It just started happening, my last two prints show the lean. Here's a photo of tonight's print, done in XT-CF20 carbon fiber filament. The angle is taken from the RIGHT side of the print...

image.thumb.jpeg.29bf6dab4f16d12490121068fe08432f.jpeg

And from a few months ago...

image22.thumb.JPG.fda331f28b1b9eef6516f0f47a985562.JPG

Any thoughts? I really hate the thought of taking the printer all apart again to repair the Z-Cap....if that's the culprit!

image.thumb.jpeg.29bf6dab4f16d12490121068fe08432f.jpeg

image22.thumb.JPG.fda331f28b1b9eef6516f0f47a985562.JPG

    • Link to post
    Share on other sites
    DidierKlein

    DidierKlein 729

    Posted
    Posted · Ultimaker Original leaning prints on heated bed

    Usually this is more related to some loose pulleys or maybe one of the short belts thats touching the panels, not sure why the z should have any effect like this?

    • Link to post
    Share on other sites
    LePaul

    LePaul 324

    Posted
    • Author
    Posted · Ultimaker Original leaning prints on heated bed

    Hi DidlerKlein Thanks for the reply.

    Well its the only change, so I suspected that might be my problem

    However unscrewing and examining the motor and pulley sounds a whole lot easier!

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Followers 1
    Go to topic listing

    • Our picks

      • Introducing the UltiMaker Factor 4

        Introducing the UltiMaker Factor 4

        ArunC posted a topic in UltiMaker 3D printers,

        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
        MariMakes

        Picked By

        MariMakes,
      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...