UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I don't remember the exact details, but in x/y direction (left/right), it shouldn't be less than 0.5mm. In z direction it can be as low as the layer height you print with (0.1mm is pretty fine and you can go lower but it takes ages to finish).
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
Nicolinux 288
Hi and welcome to the community.
I don't remember the exact details, but in x/y direction (left/right), it shouldn't be less than 0.5mm. In z direction it can be as low as the layer height you print with (0.1mm is pretty fine and you can go lower but it takes ages to finish).
Link to post
Share on other sites