Hi is this what you mean?
M190 S90.000000
M109 S210.000000
;Sliced at: Fri 20-05-2016 14:41:04
;Basic settings: Layer height: 0.2 Walls: 0.8 Fill: 20
;Print time: 6 minutes
;Filament used: 0.402m 1.0g
;Filament cost: 0.02
;M190 S90 ;Uncomment to add your own bed temperature line
;M109 S210 ;Uncomment to add your own temperature line
G21 ;metric values
G90 ;absolute positioning
M82 ;set extruder to absolute mode
M107 ;start with the fan off
G28 X0 Y0 ;move X/Y to min endstops
G28 Z0 ;move Z to min endstops
G1 Z15.0 F7200 ;move the platform down 15mm
G92 E0 ;zero the extruded length
G1 F200 E3 ;extrude 3mm of feed stock
G92 E0 ;zero the extruded length again
G1 F7200
;Put printing message on LCD screen
M117 Printing...
Recommended Posts
Nicolinux 288
Hey Dan,
welcome to the forum.
You need to provide your slicing settings in Cura or else it is impossible to see what's up. Either post screenshots or slice and save a .gcode file and then post the profile settings inside the .gcode at the bottom.
Link to post
Share on other sites