Jump to content

Edge filament - better than PLA?

Folk3d

By Folk3d
in Materials & profiles

 Share

Recommended Posts

Folk3d

Folk3d 0

Posted
Posted · Edge filament - better than PLA?

this is a newbie filament from E3D but it's really amazing, prints really smoothlu with basically no warp?! 3mm spoolworks filament IMG_7826.thumb.JPG.720604939f1768e18b284e778db8d7b5.JPG . One of the E3D guys talk about it here.https://www.youtube.com/watch?v=zWQK0-wbCzw

Has anyone here tried it yet, I haven't used anything that compares to it yet, is there a lot of choice now for filaments?

IMG_7826.thumb.JPG.720604939f1768e18b284e778db8d7b5.JPG

    • Link to post
    Share on other sites
    Labern

    Labern 774

    Posted
    Posted · Edge filament - better than PLA?

    If you read the description it says ease of use comes close to PLA. This means it's not as easy to print with.

    But it does look like it's worth a try.

    • Like 1
    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...