Cura 2.1.1 Print Bed Size & Offset

[DaHai8 74]

I can't find where to set the print bed size and offset.

It's not listed in the standard profiles, so I'm using Pursa I3 profile and need to modify it.

Any ideas where to look?

Thanks!!!

[Ddot 0]

Go to Machine -> Machine Settings

should look like this:

To add the machine you should have gone through a step prompting you to add this information. If all else fails, just add another machine profile.

[DaHai8 74]

No, this is Cura 2.1.1. That screen does not exist.

Sorry, I meant to post this in the Cura and Marlin software section. I'll repost it there.

Edited May 23, 2016 by Guest