Jump to content

Heater Error


Galad

Recommended Posts

Hi all,

We are seeing the “Heater Error” on our Ultimaker 2 - extended display. In going through the troubleshooting guide:

• Latest Firmware (Cura 15.04.6) installed

• Nozzle/Fan assembly disassembled, cleaned and reassembled.

• Confirmed that Heater and Sensor were properly installed.

• Nozzle clear of fan bracket.

Also,

• Went into advanced settings and set the nozzle temperature to 50°C; no increase/movement in readout temperature (≈ 30-45 seconds) and then “Heater Error” appears.

I assume there my be several other steps to troubleshoot the root cause (resistance of heater, PC board, etc…). Would anyone have some additional checks to go through before determining what replacement part(s) we may need.

Thanks

Paul

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...