multiple 'pause at height'

[peggyb 171]

hai Daid,

is it possible to use more then 1 'pause at height' in a model?

after slicing in Cura, only the first pause shows up, moving to the upper right corner,

then to return at the height of the complete model.

When printing: it moves to the upper right corner, adds a little height and pauses,

when resuming: it moves up the the complete height, spits out a lot of plastic and pauses,

resume again and it moves back to the model, again extruding a lot of plastic and continues.

The other pause is neglected....

[Daid 306]

It can be done, but due to how the code works you need to enter them from high to low values, if you do them the other way around it causes problems. I've done a 4 pause print a week ago.

[peggyb 171]

thank you,

that worked.

I slowed down the print on resume to get rid of the extra extruded pla,

and I think it was better for bonding to the layer underneath