UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
What 3D Printer are you using? Is it still the PrintrBot?
When you 'Home' the Printer, where does the Print Head land? On the Build Plate or off?
I Cura, Home is set to 0,0,0 so If the Print Head is off the Bed (like many Prusa I3 Printers), it will offset your prints. This can be fixed in the gCode Startup.
When I Home the printer it lands on the front left corner as you see it from the opening at the front of the printer. It is over glass completely. I looked in the gCode setup and it was blank. Is this OK?
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
DaHai8 74
What 3D Printer are you using? Is it still the PrintrBot?
When you 'Home' the Printer, where does the Print Head land? On the Build Plate or off?
I Cura, Home is set to 0,0,0 so If the Print Head is off the Bed (like many Prusa I3 Printers), it will offset your prints. This can be fixed in the gCode Startup.
Link to post
Share on other sites