The print must have unstick from the bed and the filament started to follow the hotend. That, or you got a leak. Most probably just the first.
Easy to fix. Heat to 100-120 for pla to remove the big chunks. Then lower it at 90-100 to pull the smaller more delicates parts.
Basically heat it and maintain it until you can pull the plamonster/cthulhu.
Don't worry it can happen and it should be easy (use tools to pick it up, never the fingers ofc). Just be extra careful while pulling the area near the cables or/& use a hairdryer to control the heat.
Great, thanks for the reply. I will let you know how I get on.
Recommended Posts
neotko 1,417
The print must have unstick from the bed and the filament started to follow the hotend. That, or you got a leak. Most probably just the first.
Easy to fix. Heat to 100-120 for pla to remove the big chunks. Then lower it at 90-100 to pull the smaller more delicates parts.
Basically heat it and maintain it until you can pull the plamonster/cthulhu.
Don't worry it can happen and it should be easy (use tools to pick it up, never the fingers ofc). Just be extra careful while pulling the area near the cables or/& use a hairdryer to control the heat.
Link to post
Share on other sites