Jump to content

Fusion360 fires up new instance of Cura 2.1.3

clinton

By clinton
in UltiMaker Cura

 Share

Recommended Posts

clinton

clinton 7

Posted
Posted · Fusion360 fires up new instance of Cura 2.1.3

Before I upgraded to Cura 2.1.3 (from 15.something), when I clicked the "Make" button and sent the output directly to Cura it would start Cura if it wasn't already running. If it was already running then it would add the print to bed. At 2.1.3 all that seems to have changed. If Cura is already running, Fusion360 fires up another instance.

Is there a config setting to stop it doing this?

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...