UMO - Merlin built with 250000 baud rate. Now cannot upload any other firmware Cure/Arduino

carmamir · 2016-10-16T15:09:45+0000

Unfortunately I haven't checked it and it turned out that not my workstation or Surface Pro 3 supports baud rate 250000. Now I can't upload any other firmware (cura/arduino). What should I do ?

By carmamir,
October 16, 2016 in Ultimaker 3D printers

Followers 0

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign in

Already have an account? Sign in here.

Followers 0

Go to topic listing

Our picks
- Ultimaker showcase | April 2022 | 4pm CEST | 10am EDT
  
  SandervG posted a topic in Official news, April 20
  I'm excited because I've personally produced this showcase event, so if you are curious what else I'm up to nowadays, come check it out and say hi in the chat! It would mean a lot!
  
  4 replies
  Picked By
  SandervG, April 20
- New here? Get ahead with a free onboarding course
  
  SandervG posted a topic in Official news, February 9, 2021
  Hi,
  
  Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
  Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
  They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
  Ready? Register your product here in just 60 seconds.
  
  11 replies
  Picked By
  SandervG, August 17, 2021
View All

UMO - Merlin built with 250000 baud rate. Now cannot upload any other firmware Cure/Arduino

Recommended Posts

carmamir 0

Link to post

Share on other sites

Create an account or sign in to comment

Create an account

Sign in

Our picks

Ultimaker showcase | April 2022 | 4pm CEST | 10am EDT

Picked By

New here? Get ahead with a free onboarding course

Picked By

Browse

Activity