UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Combing is traveling the print nozzle across the print without doing any retraction. That leaves a trail of filament ooze goo on the print as it goes. This is not much of an issue if it is Combing across infill. However it can make you print look not so nice if done on an outer layer (skin). So Combing ...
Off = Don't Comb. Do a Retract and Travel Everywhere
All = Do the Combing All the Time
No Skin = Do Not Comb when moving across the outer (visible) layer, do a retract/travel instead (don't ooze goo on my Skin, Baby...) but go ahead a comb on the infill.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
DaHai8 74
Combing is traveling the print nozzle across the print without doing any retraction. That leaves a trail of filament ooze goo on the print as it goes. This is not much of an issue if it is Combing across infill. However it can make you print look not so nice if done on an outer layer (skin). So Combing ...
Off = Don't Comb. Do a Retract and Travel Everywhere
All = Do the Combing All the Time
No Skin = Do Not Comb when moving across the outer (visible) layer, do a retract/travel instead (don't ooze goo on my Skin, Baby...) but go ahead a comb on the infill.
Edited by GuestLink to post
Share on other sites
ianeagland 0
Thanks
Ian
Link to post
Share on other sites