UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
It's the temp sensor cable - not the heater cable. Disconnect this cable from the board underneath and measure the resistance. It should be a steady 108 ohms or so (depending on temperature). 300 degrees is over 200 ohms I think so if the resistance is fluctuating between 100 ohms and 200 ohms that is the problem. Try jiggling the wire where it meets the heated bed. it could be the wire isn't screwed into the bed properly.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,224
It's the temp sensor cable - not the heater cable. Disconnect this cable from the board underneath and measure the resistance. It should be a steady 108 ohms or so (depending on temperature). 300 degrees is over 200 ohms I think so if the resistance is fluctuating between 100 ohms and 200 ohms that is the problem. Try jiggling the wire where it meets the heated bed. it could be the wire isn't screwed into the bed properly.
Link to post
Share on other sites