UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
· bad first layer at right upper side with UM2
I don't think this will be a problem. It will be harder to remove (will stick much better) there but it should come out just fine.
However you can turn the knob on the front left to move that corner up a bit which will tilt the opposite corner down. Also to keep the other areas the same turn the other 2 screws so that the bed moves down.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
gr5 2,230
I don't think this will be a problem. It will be harder to remove (will stick much better) there but it should come out just fine.
However you can turn the knob on the front left to move that corner up a bit which will tilt the opposite corner down. Also to keep the other areas the same turn the other 2 screws so that the bed moves down.
Link to post
Share on other sites