Jump to content

UM3, fine tuning bed height after calibration

tonnesfn

By tonnesfn
in UltiMaker Cura

 Share

Recommended Posts

tonnesfn

tonnesfn 0

Posted
Posted · UM3, fine tuning bed height after calibration

I have leveled the bed manually, and am using the active leveling now and then, but I would still love to be able to change the bed height ever so slightly when I see the bottom layer too squished or not squished enough. I could always recalibrate, but that still leaves some inaccuracies when done by hand. Is there a parameter I can change in software on the printer to add an offset to the z-height after the active leveling?

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.8 beta released

        UltiMaker Cura 5.8 beta released

        ArunC posted a topic in UltiMaker Cura,

        Another Cura release has arrived and in this 5.8 beta release, the focus is on improving Z seams, as well as completing support for the full Method series of printers by introducing a profile for the UltiMaker Method.
          • Like
        • 1 reply
        MariMakes

        Picked By

        MariMakes,
      • Introducing the UltiMaker Factor 4

        Introducing the UltiMaker Factor 4

        ArunC posted a topic in UltiMaker 3D printers,

        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...