UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
UM2's have a 25w heater that can cause this problem. That's why the UM2+ came out with a stronger heater. 35w i think.
Seeing that you are printing with PET i would suggest that you lower your fans as PET layer adhesion is not very good and having the fans on 100% is not normally the best idea.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
Labern 774
Is this a UM2?
UM2's have a 25w heater that can cause this problem. That's why the UM2+ came out with a stronger heater. 35w i think.
Seeing that you are printing with PET i would suggest that you lower your fans as PET layer adhesion is not very good and having the fans on 100% is not normally the best idea.
Link to post
Share on other sites