Jump to content

Cura 13.03 and Gen6


rbc1225

Recommended Posts

Posted · Cura 13.03 and Gen6

Daid:

One question before I install the new version of Cura on the machine I am using with my Gen 6 electronics. Since Cura gives you the option to install the Arduino software I assume I should skip this since it seems like the Gen6 is a little strange in the fact it still uses the old version of the software. Would you agree or is the verson that is installed as a part of Cura compatable with the Gen 6?

 

  • Link to post
    Share on other sites

    Posted · Cura 13.03 and Gen6

    The Arduino driver that I install is the one from the latest Arduino beta IDE (because this driver is signed by Microsoft, and thus works on Windows 8)

    You can always skip the Arduino driver install, and the rest of the code doesn't depend on this specific driver. The auto-serial-port detection might fail on Gen6 electronics, I wouldn't know that. But if it worked before it will still work now.

     

  • Link to post
    Share on other sites

    Posted · Cura 13.03 and Gen6

    Nope the autodetect didn't work before but you indicated you were going to change the connect time from 5 seconds to 10 so it might actually connect manually. I will try it when I get home and report back.

     

  • Link to post
    Share on other sites

    Posted · Cura 13.03 and Gen6

    Okay man looks good. I didn't install the Arduino as I didn't want to screw up a driver I knew already worked but you changing that delay time did the trick as far as connecting manually, so at least I can use Cura now on my old POS Gen 6 now where I could not before. Thanks again for all your hard work.

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...