Jump to content
Ultimaker Community of 3D Printing Experts
Semus

Unable to find correct firmware for my machine in Cura folders

By Semus, in Cura + plugins

Recommended Posts

Semus    0

Semus
Posted in Unable to find correct firmware for my machine in Cura folders

Hey guys, I just built a new UMO+, upgraded it with the UM2+ extrusion kit, and now I need to load custom firmware.

I was reading another forum post on this in which the user was told to place the custom firmware inside the Cura folder and replace the old firmware .hex file (while saving the old file, of course).

I can't seem to find which file is mine. There are quite a few listed, and none of them match what it says on my Ulticontroller. How can I find the correct file to replace? Or, should I just remove all the firmware .hex files, and place my custom file in the folder by itself?

Any ideas?

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Go To Topic Listing Cura + plugins

  • Our picks

    • How to 3D print with reinforced engineering materials

      How to 3D print with reinforced engineering materials

      SandervG posted a topic in Official news,

      Ultimaker is hosting a webinar where we explain how you can achieve and maintain a high print success rate using these new reinforced engineering materials. Learn from Ultimaker's Product Manager of Materials and top chemical engineer Bart van As how you can take your 3D printing to that next level.
      • 0 replies
      SandervG

      Picked By

      SandervG,
    • "Back To The Future" using Generative Design & Investment Casting

      "Back To The Future" using Generative Design & Investment Casting

      SteveCox3D posted a topic in Engineering,

      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
      SandervG

      Picked By

      SandervG,
    View All
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!

  I accept