Jump to content

Dual Extrusion Fine Tuning

Rdrost

By Rdrost
in Improve your 3D prints

 Share

Recommended Posts

Rdrost

Rdrost 0

Posted
Posted (edited) · Dual Extrusion Fine Tuning

I am trying to print this dual extrusion print with white and black PLA. Any ideas on how to fine tune this to remove the mess on top? I have tried the ooze shield, prime tower, and changing the top level jerk settings (not sure this helped, but I tried it). Nothing has shown visible improvement yet. I am printing ultimaker PLA (white and black) on normal settings in cura (0.1mm layer height). IMG_20170417_081306.thumb.jpg.ac2ee974ee47cbed85756363e6facb83.jpg

IMG_20170417_081306.thumb.jpg.ac2ee974ee47cbed85756363e6facb83.jpg

Edited by Guest
    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...