Jump to content
Ultimaker Community of 3D Printing Experts
lance-greene

coordinate positioning issues with E3D UM2 upgrade

Recommended Posts

so after installing the E3D UM2 upgrade ive noticed that while the part position in the slicer is centered, once it starts printing the part is shifted to the right on the buildplate. is there some setting that can remedy this? im trying to print a part that takes up almost the entire build area and even though i know it will fit, the printer cancels itself and says it is trying to print outside of the build area even though it has lots of room and is not near the edge at all

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 122 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!