Jump to content

Cura 2.6 0.8 mm print is seen as 0.4mm print on um2+


Recommended Posts

Posted · Cura 2.6 0.8 mm print is seen as 0.4mm print on um2+


I just updated to cura 2.6 from 2.5, but now every time I slice and save a 3d print for 0.8 mm nozzle, as soon as I put the SD card in the printer it shows as 0.4mm nozzle.

I can still print it, and it doesn't look that bad.

But what has happened here?

Much obliged.


  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    • Create New...