Jump to content

Connect Ultimaker 2 with raspberry directly on PCB


Recommended Posts

Posted · Connect Ultimaker 2 with raspberry directly on PCB

I'm making an Octoprint system, i want to put all the electronics inside the printer (with the pcb). My question is: Is possible to connect the raspberry directly on PCB? I can see pins on the board.

I would like to avoid passing the USB cable outside the printer.

Thank you.

  • Link to post
    Share on other sites

    Posted · Connect Ultimaker 2 with raspberry directly on PCB

    There are no pins on the board exposing the USB signal...

    The only thing you could do is to use the 4 test points located under the USB connector -- not sure it s good idea though...

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...