Jump to content
Ultimaker Community of 3D Printing Experts
vishalbirajdar

How to make 2 part in different material in UM 3 using cura 2.6.1? Colour not changes for extruder changes ?

Recommended Posts

5a333cc752ab1_UM3.thumb.jpg.aaaa6279f5b24818c2b272714026b753.jpg

hello all,

I am using UM3 and cura 2.6.1 i want print two parts in UM3 but need to 1 part in pla and 2nd part is in abs using dual extrusion , but in cura i am not getting these colour not changes as per shown in extruder one and for 2 ? how to apply these 1 is pla and 2 is in abs ?

5a333cc752ab1_UM3.thumb.jpg.aaaa6279f5b24818c2b272714026b753.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 114 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!