Jump to content
Ultimaker Community of 3D Printing Experts

Cura 2.6.2 Dual Extruder Start Gcode


rvator
 Share

Recommended Posts

Posted · Cura 2.6.2 Dual Extruder Start Gcode

I am trying to set up the machine settings for my BigBox Dual in Cura 2.6.2. By default cura heats up both extruders although only one extruder is used. There is a tab for Extruder1 and Extruder2 in Machine settings but if I edit the start code in one of these tabs, it has no effect on the generated gcode.

I would like to heat up both extruders to soften eventally oozed material on the unused extruder before bed leveling and switch off heating the unused extruder afterwards.[media=68749][/media]

[media=68750][/media]

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...