I measured 110 Ohm on the gold pads so it's not a cable problem it seems, and yes the original core works fine.
That's weird then. The only one thing I can think of right now is cleaning the pads with a little bit of alcohol because of grease or other stuff preventing the pads from making a good contact.
Found out! There was a short circuit between the PT100 Contacts and the small connector (some solder) that is present on Solex only. I don't know why they put this connector but, they had to put the wire too close to each other... not a good design (layout speaking). Anyway, it's working now.
Glad you found it.
I'd advise you to give this feedback to Solex as well!
Recommended Posts
Marco_TvM 34
If the originals PrintCores are working, and the ones from 3D Solex aren't, it seems to be a problem with the 3D Solex cores.
If you use a meter to measure the resistance of the PT100 should be slightly above 100Ohm (100Ohm @ 0 degrees C). The pins to measure are the 2 right pins on the print core.
A value of infinite will cause the problem with the MAX_TEMP_ERROR, and might be just because of a broken cable.
Link to post
Share on other sites