bob-hepple 59
I know all machines are different on my UM2 I print well below 200 around 185 / 190
where as on my sigma I only just started printing at 205 to get a decent print.
going to give the calibration print your using a go, at 0.1, yeah bridges for me are also a problem.
Recommended Posts
paul9 20
Hi any of you can help me understand how to install and edit the printing area for this fan duct solution?
I also wrote to the creator but he did not answer me.
I would like to understand what the Stl file called Switch is and what it is used for.
https://www.youmagine.com/designs/super-fan-duct-for-ultimaker-delicious-clam
Link to post
Share on other sites