Jump to content
Ultimaker Community of 3D Printing Experts
lepper

Filament don't entering to the nozzle properly

Recommended Posts

Hello from couple days i have problem with my ultimaker 2 when i load filament every thing going good i start printing and when print finish and I takting tube out it s looking like that

http://imgur.com/gqCngYg

https://ibb.co/i1jD2F

and i dont know what i have to do with this i clear every thing I changed PTFE tube and all the time it s the same i tryed higher and lower temperaturs and all the time it s the same

Edited by Guest

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 114 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!