Jump to content
ryandavidson

Infill not printing correctly

Recommended Posts

Posted · Infill not printing correctly

5a333e8fde5a7_2017-08-2315_27_53.thumb.jpg.d962fac79039006d2623bf5e8b50b149.jpg

Some of the lines of my infill are looking a bit sad, like its under extruding. Infill settings default for 20% density.

Share this post


Link to post
Share on other sites
Posted · Infill not printing correctly

Personnaly i find that the default profiles have to high infill speeds, you can change them and lower them to the main printing speeds (if the infill speed is not visible click on the gear next to printing speeds to make it appear).

Share this post


Link to post
Share on other sites
Posted · Infill not printing correctly

Personnaly i find that the default profiles have to high infill speeds, you can change them and lower them to the main printing speeds (if the infill speed is not visible click on the gear next to printing speeds to make it appear).

Sounds good, ill give it a go!

Cheers

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!