Hi,
If you have no experience in 3d printing i would advise to first try single prints with PLA.
Regarding your issue, wild guess would be that the print bed is to low, did you do the active levelling? Also, i would advise to use Cura instead of the phone app because it's limited in features.
Hi, thanks for your reply. I'm trying active levelling but it doesn't work since the UM says there's a non-realistic difference in height of both printcores. Indeed I see that on the right side while performing the levelling the second printcore doesn't touch the bed glass. It has been a while I'm trying manual levelling to fix the active one but no way!
Edited by Guest
Recommended Posts
DidierKlein 729
Hi,
If you have no experience in 3d printing i would advise to first try single prints with PLA.
Regarding your issue, wild guess would be that the print bed is to low, did you do the active levelling? Also, i would advise to use Cura instead of the phone app because it's limited in features.
Link to post
Share on other sites