Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.
Recommended Posts
Marco_TvM 34
The printer cannot distinguish between Generic and color generic... because the menu structure to make that would be quite cumbersome to work with...
Hence PC (Generic) and only NFC detected PC (White/other_colors).
Because that doesn't match with Cura's selected profiles for slicing, you have to agree to override.
I think this is a question for Cura and not the firmware section.
So maybe @Msuurmond is able to answer this.
Edited by Marco_TvMLink to post
Share on other sites
Gigi 43
No problem. I'l override.
Link to post
Share on other sites