Jump to content
Ultimaker Community of 3D Printing Experts

13.06.2 COM detection on XP SP3


jeroen-teunissen

Recommended Posts

Posted · 13.06.2 COM detection on XP SP3

I have some strange problem with Cura 13.06.02 after updating from 12.11 on 2 machines runnging XP SP3.

Cura doesn't connect to the printer. Both COM-port and Baudrate to AUTO, but when running the "first time setup" it shows "Communication" ok, even states Communication State: operational but it can't get to the temperature and endstops test.

Actually, when you skip the checks it cannot connect to the printer because..:

"Failed to establish connection with the printer". Strange, because the Communication State shows operational.

What i tried:

- Disabled firewall

- Disabled anti-virus

- reinstalled Arduino COM driver

- Set port and baudrate manually

- Update firmware to Marlin 250000

- Updated Python from 2.7 to 3.3 (because of some other display probs - solved)

Cura 12.11 works perfectly on both machines while 13.06.2 doesn't, on both machines. So; what am i doing wrong, on both machines (besides running XP SP3)?

 

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...