Change print speed dependent on height

[mgudor 0]

I did some searching but likely don't know the 'key terms' to use, so my apologies if this has been asked/solved already.  Long story short, I  print on an Anet A8 and e10 where the bed moves in the y-direction.  I have gotten serviceable prints by changing speeds/etc.  Where I am running into trouble is with taller prints at a decent speed (60 mm/s).  I believe much of the problem comes from the y-axis moving back and forth with a long (tall) object on the bed.  I was wondering if Cura allows me to set the speed based on layer height.  I do slow down the speed for brim/initial layer, but I was thinking I could print ~ 80 mm/s for the first 'x' layers, and then slow down as the object gets taller.

 

I thank you in advance.

[andremilton 1]

Hi this is exactly what i'm searching for:

 

When i print a tall piece , the wobble is linked to the height , because of acceleration and deceleration of the Y axis i presume.

 

maybe i'm going to try to make a script , but it seems extruder speed should also change with print speed on post treatment side

Edited May 1, 2020 by andremilton

[Salo92 0]

Hello, I am also looking for this option to combat ringing on tall prints. Did you ever find a solution?

 

Edit: I found it, you can add a post processing script called "ChangeAtZ" Under the Extensions tab.

Edited August 9, 2021 by Salo92

[Cuq 202]

There is a plugin call slow at z% for that . But it's not in the official list : https://github.com/VMaxx/SlowZ