Jump to content

After upgrading to 3.3.1 I have issues


JohnathanSmith1969

Recommended Posts

Posted · After upgrading to 3.3.1 I have issues
I am using a Select Plus Printer... After upgrading to the Mac version of Cura 3.3.1 today I have a issue after every job my printer makes a banging sound, the filament breaks off  and then I need to restart it to access the menus?
 
Can it be something in my End Gcode?
 
End Gcode:
M117 Cooling down . . .
M300 ;beep
M104 S0 ;extruder heater off
M140 S0 ;heated bed heater off (if you have it)
G91 ;relative positioning
G1 E-1 F300 ;retract the filament a bit before lifting the nozzle, to release some of the pressure
G1 Z+0.5 E-5 X-20 Y-20 F9000 ;move Z up a bit and retract filament even more
M106 S255 ;fan at 100% to cool nozzle
G28 X0 Y0 ;move X/Y to min endstops, so the head is out of the way
G90 ;absolute positioning
G1 X100 Y190 ;move bed forward
M84 ;steppers off
M117 Cooling down . . .
G4 P120000 ;wait 2 minutes (120 seconds)
M106 S0 ;fan off
M117 Finished!!!
M300 ;beep
  • Link to post
    Share on other sites

    Posted · After upgrading to 3.3.1 I have issues

    Not all firmwares set extrusion mode to relative using G91 (e.g. RepRap doesn't but Marlin does). Maybe you also need an M83? Doesn't really explain what you're seeing.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 7 replies
      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
    ×
    ×
    • Create New...