Jump to content

Tool Change Location


AbeFM

Recommended Posts

Posted · Tool Change Location

I'm super happy to see that CURA waits for the nozzles to get to temperature unlike certain competitors.

 

However this is happening right on the part! Could we do these temperature changes over the purge tower, instead of doing them on the part, then moving to the purge tower immediately following?

 

Or, is there some way to do this (or at least Z-lift during temp changes)?

  • Link to post
    Share on other sites

    Posted · Tool Change Location

    Could we add a tool change script that moves to that position, manually, at the beginning of each tool change? Would that happen before the temperature set?

  • Link to post
    Share on other sites

    Posted · Tool Change Location

    I added a (manual, fixed) G1 X<where I put the prime tower> Y<Where I put the prime tower> to the "tool end script" in printer settings.

     

    This works, but has the problem that when there is no heat up time needed you run over to the tower needlessly. This is basically ok, I guess. It has helped a ton with blobbing and failed parts.

  • Link to post
    Share on other sites

    Posted · Tool Change Location

    Thanks for the link!

     

    Unfortunately, I'm not seeing how to use that to get my printer to perform the requested operation. It does not appear the OP got it working either.

     

    Could you give me a sentence or two which gets me going?

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...