Cura 3.3.1 files not suitable for printer

[Maurice789 0]

I had installed 3.3.1 but all files were ER26. "Not Suitable for this printer" UM3 Extended.

Printer type. PrintCores and Materials were set ok in Cura.

 

I have now installed 3.0.1. back on PC. And all files are fine again.

Any ideas ?

[ultiarjan 1,223]

I had some issues with profiles myself, did a clean install and all was fine. You could try a clean install, here's where all the files are you need to delete (or backup....)

 

https://github.com/Ultimaker/Cura/issues/3051