Here's my start g-code:
G21; Metric values
G90; Absolute positioning
M107; Fan off
G28; Home the printer
G92 E0; Zero the extruder
G0 E4 F500; Extrude 4mm to prime nozzle
The only time I have an outright Z1 movement is at the end, and it's in relative mode at that point. None of the g-code I looked at has a Z15 movement, other than the Pause at Height change on 2 models. So I'm at a loss.
Where do I place the modified script? I ran a search and found pauseAtZ.py and tweakAtZ.py but don't see the other 6 post-processing scripts listed in Cura 3.3.1
58 minutes ago, b-morgan said:I'd be willing to bet those initial Z height changes are coming from the start gcode for your printer. If so, then they are executed before there's anything on the print bed.
The current Pause at Height post processing script, however, isn't very smart and it see's those changes in Z and will insert its gcode into the middle of your printer's start gcode.
I have solved this problem by modifying the script, see below:
Recommended Posts
b-morgan 1
I'd be willing to bet those initial Z height changes are coming from the start gcode for your printer. If so, then they are executed before there's anything on the print bed.
The current Pause at Height post processing script, however, isn't very smart and it see's those changes in Z and will insert its gcode into the middle of your printer's start gcode.
I have solved this problem by modifying the script, see below:
Link to post
Share on other sites