Jump to content

Paying via Paypal deposit

theiso
 Share

Recommended Posts

theiso

theiso 0

Posted
Posted · Paying via Paypal deposit

Hello,

Is it possible to order the ultimaker via the paypal deposit? Because I don't have an credit card with sufficient limit and would like to charge my paypal account from my bank account and pay with the deposit.

I'm from Germany, most people here don't use credit cards, because of low limits or high fees.

best regards,

Theiso

 

    • Link to post
    Share on other sites
    ian

    ian 32

    Posted
    Posted · Paying via Paypal deposit

    why not simply do a wire transfer from your normal german bank account to the ultimaker account.

    I have done this twice and it works perfectly !!

    Liebe Grusse aus Leipzig.

    Ian :-)

     

    • Link to post
    Share on other sites
    jonnybischof

    jonnybischof 60

    Posted
    Posted · Paying via Paypal deposit

    If PayPal deposit means you pay with money that you have put on your PayPal account, then yes this works!

    Just did it a few hours ago ;)

    /edit:

    I think PayPal is faster than wire transfer? For me that's a good reason ;)

     

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Followers 0
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...