Jump to content

OHM2013 Europes biggest hacker conference


snowygrouch

Recommended Posts

Posted · OHM2013 Europes biggest hacker conference

Bit late now really to put this up on here....as its sold out. WHoops :oops:

However it might serve as a notification to look out for eachother if

anyone else is going.

https://ohm2013.org/site/

So its from this Wednesday until Sunday. There is a fair bit of general

REPRAP stuff going on, I believe that Mr Prusa himself is doing

a lecture also.

I will be talking about making metal castings from Ultimaker parts, on the

Wednesday 3pm on main stage.

Anyway, hope that someone might be dropping by especially from the Netherlands.

being just north of Amsterdam.

Regards

C.

 

  • Link to post
    Share on other sites

    Posted · OHM2013 Europes biggest hacker conference

    I know Harma from Ultimaker will be there (not sponsored by Ultimaker, just by herself). I won't be there (shame, I would have loved to go there)

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
    ×
    ×
    • Create New...