Jump to content

Ultimaker ABS and Original glass bed.


Hokololo

Recommended Posts

Posted · Ultimaker ABS and Original glass bed.

Hello all, 

 

I had a bad experience again with Ultimaker ABS. This material is very tricky. It sometimes sticks on to the glass bed too much, and it eventually rips off the surface of the glass bed just like PETG. I have seen many of glass chipping events but not this much severe one. I hope people see these pictures and avoid the same mistake. ?  

 

IMG_6283.thumb.JPG.dd81e2f29e43deefa051f35d449b829b.JPGIMG_4137.thumb.JPG.4be46585481fc262b4aee4f31964ca56.JPGIMG_0319.thumb.JPG.e0f8ed7431cfbcd664b7be337ca735b7.JPG

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...