3D Chicken

[reprofish 0]

This is driving me nuts. The 3D chicken image was made in Agisoft. It was saved as a OBJ file. When I open it in Cura I get the flat graph looking file thing. I've uploaded and printed other OBJ files with no problems. Is the problem in Agisoft or Cure? Kinda like the chicken and egg question. Bob from New Jersey USA 

[kmanstudios 1,120]

Without the file to look at, it is impossible to tell what it should look like.

 

[reprofish 0]

Kman, I think the answer is somewhere within my settings. I've printed dozens of items with no problems. I guess it should look like a chicken?   

[kmanstudios 1,120]

you would think so, but just because you got some good prints does not mean that the file if FUBAR. I have seen it happen. Or, run it through a mesh checking site.

[reprofish 0]

Will do. Keep you posted.