Jump to content
Ultimaker Community of 3D Printing Experts

Cura 3.5 issue - Strange/Bad travel paths, jumping


GeriX
 Share

Recommended Posts

Posted · Cura 3.5 issue - Strange/Bad travel paths, jumping

Hello folks!

Since the new update I got the issue, that the printer prints all the straight lines individually and jumps from line to line, instead of printing one continuos path.

This results in a lot of jumpin around, stringing and lack of adhesion, as none of the lines are well connected. Here is a video of the issue.

My printer is a CR10s. Is there a new setting that produces this behaviour?

 

Thank y'all for your help!

  • Link to post
    Share on other sites

    Posted · Cura 3.5 issue - Strange/Bad travel paths, jumping

    Hi @GeriX, I have taken a quick look at your files and can't see anything obviously wrong apart from the fact that you have z-hop set to 3mm which is, perhaps, somewhat OTT (literally).

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...