Jump to content
savak001

Layer processing

Recommended Posts

Posted · Layer processing

Hi all

 

I have the same problem as other with the dreaded 'Layer Processing' never finishing.

The layers are shown as are the sliders to the right of the model enviornment box.

 

This happens despite clearing the computer of all versions of Cura, I'm using 3.5, restarting, using CCleaner to clean the Registry etc.

 

What's going on?

How is it resolved?

 

All help welcome.

 

Regards

Graeme Craig

Share this post


Link to post
Share on other sites
Posted · Layer processing

Have you set your cura on automatic processing? it does not slice automatically so this can maybe be the problem.  If you press the button that your normally use for saving the gcode (it should say prepare) you can do this by hand. 

Share this post


Link to post
Share on other sites
Posted · Layer processing

I load a model orintate as required, change any settings then slice. Thats when the error arises.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!